Sanitary Neutral Cure Anti-Fungal Silicone Adhesive / Sealant

SA Sanitary Silicone Sealant is a one-part, 100% oxime, neutral curing adhesive/sealant containing anti-fungicide to prevent mould growth. It resists mildew when exposed to prolonged hot and humid environments and is suitable for sealing in kitchens, vanities, bathrooms, shower screens and any other wet area applications.

Packaging: 300gm Cartridges - in cartons of 20.

Colour Options: White, Clear (Transperent)

 FEATURES

• Non Slump
• Mildew Resistant
• One Part Ready To Use
• Outstanding Weatherability
• Excellent Adhesion
• Excellent Uv Resistance
• 5 Star VOC Compliant

USES & APPLICATIONS

SA Sanitary has excellent adhesion to glass, ceramics, aluminium, masonry, stone, concrete, most metals and many plastics.It may be used for general glazing and weatherproofing applications including wet areas and humid environments.

APPLICATION:

• Surfaces must be clean, dry and free of dirt, grease, oil, rust and water. Use white spirits or mechanical cleaning with a lint-free cloth. Do not use soap or detergent. For plastics, contact Sealants Australasia for a recommended cleaning solvent. When used on remedial work all existing sealant must be removed before application of new material.

• Cut the nozzle at 45 45-degree angle to the desired bead width, and apply to the substrate with a sealant gun and tool within 5-10 minutes.

• Uncured sealant can be cleaned up with mineral turpentine.

• Some surfaces may need a primer. If so, allow the primer to dry before applying sealant.

• Use approved backing material for joints over 10mm deep. For a neat appearance to the joint, use masking tape.Always remove the masking tape before the sealant has skinned over.

LIMITATIONS 

SA Sanitary is not recommended for use on submerged joints where porous substrates permit water to the bond interface. Not for certain rubber products where bleeding of plasticiser may occur, or horizontal walkways where sealant will be subject to abrasion. Cannot be painted. Not recommended for use on polycarbonate plastic. Suitability for use on other types of plastic including extruded gutter profiles should be tested prior to application.